Microplastic contamination in water and sediments of Mahanadi River, India: An assessment of ecological risk along rural-urban area.
Worldwide, environmental concerns about MPs pollution have increased. Microplastic contamination that pollutes the ocean is mostly caused by terrestrial transfer from close proximity locations. A study of MPs pollution near coastal locations becomes necessary to address the MPs transit, fate, and mitigation. In the current study MPs pollution in the surface water and sediment of the Mahanadi River estuary was assessed during Pre-MS and MS. The size, shape, and colour of the MPs were determined using a stereomicroscope, and the MPs polymer composition was identified by Attenuated Total Reflection-Fourier Transform Infrared (ATR-FTIR) spectroscopy. The mean concentration of MPs that were potentially discovered in water was 16.6 ± 5.2 and sediments 197.3 ± 5.4 during Pre-MS. In the MS observed mean abundance of MPs was 15.1 ± 5.4 in water and 164.6 ± 76.9 in sediments. The highest abundant size was smaller than 1 mm; the most prevalent shape were fibers followed by film and fragments; black and white was a prominent colour in water and sediments respectively. Polyesters (PEs), polyethylene (PE), polyvinyl chloride (PVC), polypropylene (PP), polyamide (PA), Polystyrene (PS), and Polycarbonates (PC) were found in the analysis of the chemical composition of MPs in water and sediments samples. The calculated PLI value shows pollution load at category I, with polymer hazard levels at categories III, IV, and V, indicating very high risk. The current research results show that river inflows and fishing-related actions are probably the main causes of MPs pollution.
Patidar K
，Ambade B
，Verma SK
，Mohammad F
... -
《-》
Occurrence, characteristics, and risk assessment of microplastics and polycyclic aromatic hydrocarbons associated with microplastics in surface water and sediments of the Konya Closed Basin, Turkey.
The presence of polycyclic hydrocarbons (PAHs) and microplastics (MPs) in aquatic environments affects the ecosystems and threatens human health. In this study, the abundance, composition, and morphological characteristics of MPs were determined for the first time in the inland freshwater resources of the Konya Closed Basin, Turkey. The abundance of MPs ranged from 1139 to 23,444 particles/m3 and 150 to 3510 particles/kg in the surface water and sediment, respectively. Fragments and fibers were the most abundant MP shapes in the surface waters (51%, 34%) and sediments (29%, 40%), followed by films, pellets, and foams. Transparent and white MPs were present at the highest percentage in surface waters (72%) and sediments (69%), followed by blue, grey, black, brown, and green. In addition, polyethylene, polypropylene, and cellophane were identified as the main polymers in surface waters (34%, 25%, 24%) and sediments (37%, 17%, 31%). In the Konya Closed Basin, 35% of the surface water samples and 54% of the sediment samples were exposed to very high contamination (CF ≥ 6). Surface waters (PLI: 2.51) and sediments (PLI: 1.67) in the basin were contaminated (PLI > 1) with MPs. The 16 PAHs sorbed on MPs in the surface water and sediment ranged from 394 to 24,754 ng/g and from 37 to 18,323 ng/g, respectively. Phenanthrene and fluoranthene were the most abundant PAHs sorbed on MPs in all surface waters and sediments. Two to three-ring PAH compounds sorbed on MPs were also dominantly detected in surface waters and sediments, accounting for 68% and 78% of the total 16 PAHs, respectively. The source of PAHs carried by MPs in the Konya Closed Basin was mainly of petrogenic origin. Incremental lifetime cancer risk (ILCR) results indicated that the maximum ILCR values were higher than the EPA acceptable level (10-6) for child (2.95 × 10-5) and adult (1.46 × 10-4), indicating a potential cancer risk.
Aydin S
，Ulvi A
，Aydin ME
《-》
An assessment of microplastic contamination in beach sediment of Maharashtra State, India, with special reference to anthropogenic activities.
The escalating issue of microplastic (MP) pollution poses a significant threat to the marine environment due to increasing plastic production and improper waste management. The current investigation was aimed at quantifying the MP concentration on 25 beaches on the Maharashtra coast, India. Beach sediments (1 kg) were collected from each site, with five replicates to evaluate the extent of MPs. The samples were homogenized, and three 20 g replicas were prepared for subsequent analysis. Later, the samples were sieved, and MPs were extracted using previously published protocols. The abundance of MPs found as 1.56 ± 0.79 MPs/g, ranges from 0.43 ± 0.07 to 3 ± 0.37 MPs/g. Fibers were found as the most abundant shape of MPs. Size-wise classification revealed dominance of <1 mm and 1-2 mm-sized MPs. Blue- and black-colored MPs were recorded dominantly. Polymer identification of MPs revealed polyurethane, polypropylene, polyvinyl chloride, acrylic or polymethyl methacrylate, and rubber. The findings revealed that MPs were found to be higher at highly impacted sites, followed by moderately impacted sites and low-impacted sites, possibly due to a different degree of anthropogenic pressure. The study recommended the urgent need for effective policy to prevent plastics accumulation in the coastal environment of Maharashtra State, India. PRACTITIONER POINTS: The study investigated the abundance and distribution of microplastics in the marine environment, specifically in sediments. The most common type of microplastic found was fibers, followed by fragments and films. Microplastics were found to pose a potential risk to the marine ecosystem, although further research is needed to fully understand their ecological impact. Future research should focus on expanding the sample size, assessing long-term effects, exploring sources and pathways, and considering size and shape of microplastics. The findings recommended urgent action to mitigate plastic pollution in Maharashtra coast.
Shinde R
，Rabari V
，Duggal R
，Patel A
，Alharbi SA
，Ansari MJ
，Trivedi J
... -
《-》
Pollution characteristics and ecological risk of microplastic in sediments of Liaodong Bay from the northern Bohai Sea in China.
Microplastics (MPs) are widely distributed in marine environments. The pollution characteristics and risk assessment of MPs in estuarine sediments are still insufficient. In this study, the MPs pollution characteristics in surface sediments of the Liao Estuary and Daliao Estuary were investigated. The characteristics of MPs in sediments were determined by stereo microscopy and micro-Fourier transform infrared spectroscopy. The results showed that the average MPs abundance ranged from 32.33 to 49.91 items·kg-1 d.w. The MPs were mainly composed of 500-2000 μm black and blue fibers. Five polymer types were identified, including rayon (RA) (87.46 %), polyethylene terephthalate (PET) (6.81 %), polyamide (PA) (2.94 %), polypropylene (PP) (2.17 %) and polyethylene (PE) (0.62 %). The pollution load index (PLI) risk assessment showed that all sampling sites were at Hazard Level I. Our results can provide useful information for assessing the environmental risks of MPs in coastal areas of China.
Ye Y
，Zhang A
，Teng J
，Yang X
，Yuan X
，Wang Q
，Zhao J
，Zhang B
，Zhang T
，Chen X
，Guan T
，Ma X
... -
《-》
ResearchGate
(全网免费下载)
钛学术
(全网免费下载)
