Abundance and distribution of microplastics on sandy beaches of the eastern Moroccan Mediterranean coast.

Microplastics (MPs) were investigated at 19 sandy beaches along the eastern Mediterranean Moroccan coast. Sediment samples (5 mm-63 μm) were analyzed to identify MPs abundance, size, shape, color and nature. MPs concentration ranged from 40 ± 7.4 to 230 ± 48.6 MPs kg-1; fibrous MPs were the most abundant (74.72 %), followed by fragments (20.26 %), films (3.27 %), pellets (1.42 %) and foams (0.33 %). Large MPs (1-5 mm) accounted for 58 %, while small (< 1 mm) for 42 %. The 1-2 mm fraction of sediments presented the greatest amounts (30.67 %) of MPs. Transparent (50 %) and blue (17 %) were most common colors and most of particles were angular and irregularly shaped. Fourier Transform Infrared Spectroscopy (FTIR) analysis showed that PE (Polyethylene), PS (Polystyrene) and PP (Polypropylene) and PVC (Polyvinyl chloride) were the most common polymers. These findings revealed a moderate level of microplastic pollution along the beaches of the eastern Moroccan Mediterranean coast.

Azaaouaj S ，Nachite D ，Anfuso G ，Er-Ramy N ... -  《-》

Effect of lithological properties of beach sediments on plastic pollution in Bodrum Peninsula (SW Türkiye).

The effects grain size on transport and retention of plastics in sediments are controversial issue. Four beaches were selected on the Bodrum Peninsula (SW Türkiye) for this study. Twenty-four samples with poorly to well sorted, sandy gravel, gravel, or gravelly sand were collected from the top five cm of the sampling quadrant's four corners and center of 1 m2 area, from shoreline and backshore. The highest plastic content (38 mesoplastics/600 g - 455 microplastics (MPs)/1200 g) was determined on the Bodrum Coast having the highest population. Polyethylene (PE), polypropylene (PP), polyvinyl chloride (PVC), polystyrene (PS), polyethylene terephthalate (PET) and polyurethane (PU) were predominantly detected with Fourier Transform Infrared Spectroscopy (FTIR) analysis as MPs as a fragment and fiber. This study indicates the negative correlation between grain size and the number of MPs in coastal sediments. Anthropogenic activities are evaluated as a possible primary source of plastic pollution in the study area.

Masud A ，Gül M ，Küçükuysal C ，Buluş E ，Şahin YM ... -  《-》

Evidence of microplastics pollution in coastal beaches and waters in southern Sri Lanka.

The abundance of microplastics (MPs) in surface water and beach sediment in Southern Sri Lanka covering a distance of 91 km of coastline is reported. MPs were classified according to polymer type, geometry and color of the sites tested 60% showed MP contamination in sand and 70% in surface waters off the coast. The size range of MPs from surface waters and beaches were to 1.5-2.5 mm and 3-4.5 mm, respectively. Majority of these were identified as polyethylene (PE) and polypropylene (PP) with some polystyrene (PS) foam at a few sites. Fragments derived from larger debris appears to be the dominant type of MP at most sites and only 2 sites showed virgin pellets that accounted for 14% of the samples collected.

Bimali Koongolla J ，Andrady AL ，Terney Pradeep Kumara PB ，Gangabadage CS ... -  《-》

Quantitative assessment of microplastic in sandy beaches of Gujarat state, India.

The present study was carried out to quantify microplastic prevalence among 20 sandy beaches on the Gujarat coast. Beaches were categorised into three different classes, viz. low-impacted sites, moderately impacted sites, and highly impacted sites based on anthropogenic pressure. Microplastic (MP) (≤ 5 mm) contamination on the beaches varied with an average of 1.4 MPs/kg to 26 MPs/kg sediment. Sutrapada site-1 and Porbandar showed the highest and lowest mean abundance of microplastics, respectively, among 20 selected beaches. Out of the total assessed microplastics, threads were the maximum (89.98%), followed by the films (4.75%), fragments (3.36%) and foam (1.89%). In terms of colour and size, different microplastics were recorded in this study. The chemical composition of microplastics was identified by ATR-FTIR as polypropylene (47.5%), polyethylene (26%), and polystyrene (25%). Tourism and fishing activities are the possible sources of higher microplastic contamination at highly impacted sites.

Rabari V ，Patel K ，Patel H ，Trivedi J ... -  《-》

Microplastic contamination in water and sediments of Mahanadi River, India: An assessment of ecological risk along rural-urban area.

Worldwide, environmental concerns about MPs pollution have increased. Microplastic contamination that pollutes the ocean is mostly caused by terrestrial transfer from close proximity locations. A study of MPs pollution near coastal locations becomes necessary to address the MPs transit, fate, and mitigation. In the current study MPs pollution in the surface water and sediment of the Mahanadi River estuary was assessed during Pre-MS and MS. The size, shape, and colour of the MPs were determined using a stereomicroscope, and the MPs polymer composition was identified by Attenuated Total Reflection-Fourier Transform Infrared (ATR-FTIR) spectroscopy. The mean concentration of MPs that were potentially discovered in water was 16.6 ± 5.2 and sediments 197.3 ± 5.4 during Pre-MS. In the MS observed mean abundance of MPs was 15.1 ± 5.4 in water and 164.6 ± 76.9 in sediments. The highest abundant size was smaller than 1 mm; the most prevalent shape were fibers followed by film and fragments; black and white was a prominent colour in water and sediments respectively. Polyesters (PEs), polyethylene (PE), polyvinyl chloride (PVC), polypropylene (PP), polyamide (PA), Polystyrene (PS), and Polycarbonates (PC) were found in the analysis of the chemical composition of MPs in water and sediments samples. The calculated PLI value shows pollution load at category I, with polymer hazard levels at categories III, IV, and V, indicating very high risk. The current research results show that river inflows and fishing-related actions are probably the main causes of MPs pollution.

Patidar K ，Ambade B ，Verma SK ，Mohammad F ... -  《-》