First record of characterization, concentration and distribution of microplastics in coastal sediments of an urban fjord in south west Norway using a thermal degradation method.

Plastic waste is of increasing concern in the aquatic environment. A large proportion of plastic waste is generated onshore from where it eventually reaches the marine environment, which is considered the main sink of plastic debris To date there is a substantial lack of knowledge on the composition of these accumulated polymers, their environmental levels and distribution in marine and coastal areas. Current efforts are underway to develop standardized methods to characterize and quantify the occurrence of microplastic in different environmental matrices using microscopy-oriented methods using Fourier Transformed Infra-Red (FTIR) or Raman techniques. However, time-consuming sample preparation, processing and interpretation of complex data limits their use within monitoring programs. As an alternative, a thermal degradation method based on a gas chromatographic mass spectrometer coupled with pyrolysis represents a validated method for qualitative and quantitative polymer analyses. A technique has been developed that combines sample preparation and thermo-analysis for identifying microplastics in samples of marine sediment. Quantification and polymeric composition of plastic particles found in sediment samples taken from ten sites located in Boknafjorden subjected to diverse sources of pollution and anthropogenic pressure were investigated. Plastic microparticles were extracted from 8 kg of wet sediments per site, purified, size-fractionated thorough a set of stainless-steel certified sieves covering the range of 10-250 μm mesh size, pre-concentrated on fiberglass filters and whole filters analyzed by thermal desorption pyrolysis gas chromatography/mass spectrometry. Most of the detected polymers were identified as polypropylene, polyethylene, polyethylene terephthalate, polyvinylchloride, polystyrene or polyamide. In most of the sites, the largest fraction of the extracted micro debris fell in the size range 10-40 μm. Some shifts in size distribution were also observed in some sites and were likely related to the marine sea bottom currents and the influence of specific anthropogenic activities. The adopted thermal degradation method showed good sensitivity, reliability and rapidity and therefore represents a promising technique for microplastic analysis within monitoring activities.

Gomiero A ，Øysæd KB ，Agustsson T ，van Hoytema N ，van Thiel T ，Grati F ... -  《-》

Occurrence and spatial distribution of microplastics in sediments from Norderney.

The spatial distribution of small potential microplastics (SPM) (<1 mm) in beach sediments was studied on a 500 m stretch of the North Sea island of Norderney. Their correlation with visible plastic debris (VPD) (>1 mm) was also examined. Small microparticles were extracted from 36 one kg sediment samples and analysed by visual microscopic inspection and partly by thermal desorption pyrolysis gas chromatography/mass spectrometry. The smallest particle size that could be analysed with this method was estimated to be 100 μm. The mean number of SPM at the three sampling sites (n = 12) was 1.7, 1.3 and 2.3 particles per kg dry sediment, respectively. SPM were identified as polypropylene, polyethylene, polyethylene terephthalate, polyvinylchloride, polystyrene and polyamide. The organic plastic additives found were benzophenone, 1,2-benzenedicarboxylic acid, dimethyl phthalate, diethylhexyl phthalate, dibutyl phthalate, diethyl phthalate, phenol and 2,4-di-tert-butylphenol. Particles were distributed rather homogenously and the occurrence of SPM did not correlate with that of VPD.

Dekiff JH ，Remy D ，Klasmeier J ，Fries E ... -  《-》

Abundance and distribution of microplastics in the surface sediments from the northern Bering and Chukchi Seas.

Worldwide the seafloor has been recognized as a major sink for microplastics. However, currently nothing is known about the sediment microplastic pollution in the North Pacific sector of the Arctic Ocean. Here, we present the first record of microplastic contamination in the surface sediment from the northern Bering and Chukchi Seas. The microplastics were extracted by the density separation method from collected samples. Each particle was identified using the microscopic Fourier transform infrared spectroscopy (μFTIR). The abundances of microplastics in sediments from all sites ranged from not detected (ND) to 68.78 items/kg dry weight (DW) of sediment. The highest level of microplastic contamination in the sediment was detected from the Chukchi Sea. A negative correlation between microplastic abundance and water depth was observed. Polypropylene (PP) accounted for the largest proportion (51.5%) of the identified microplastic particles, followed by polyethylene terephthalate (PET) (35.2%) and rayon (13.3%). Fibers constituted the most common shape of plastic particles. The range of polymer types, physical shapes and spatial distribution characteristics of the microplastics suggest that water masses from the Pacific and local coastal inputs are possible sources for the microplastics found in the study area. In overall, our results highlight the global distribution of these anthropogenic pollutants and the importance of management action to reduce marine debris worldwide.

Mu J ，Qu L ，Jin F ，Zhang S ，Fang C ，Ma X ，Zhang W ，Huo C ，Cong Y ，Wang J ... -  《-》

Microplastics in sediments of the Changjiang Estuary, China.

Microplastics are plastics that measure less than 5 mm in diameter. They enter the marine environment as primary sources directly from industrial uses, as well as secondary sources resulting from the degradation of large plastic debris. To improve the knowledge of microplastic pollution in China, we investigated samples from 53 estuarine sediment locations collected with a box corer within the Changjiang Estuary. Microplastics (<5 mm) were extracted from sediments by density separation, after which they were observed under a microscope and categorized according to shape, color and size. Identification was carried out using Micro-Fourier-Transform Infrared Spectroscopy (μ-FT-IR). The abundance of microplastics in the Changjiang Estuary was mapped. The mean concentration was 121 ± 9 items per kg of dry weight, varying from 20 to 340 items per kg of dry weight. It was found that the concentration of microplastics was the highest on the southeast coast of Shanghai. The distribution pattern of microplastics may be affected by the Changjiang diluted water in summer. All of the microplastics collected were categorized according to shape, color and size. Among which fiber (93%), transparent (42%) and small microplastics (<1 mm) (58%) were the most abundant types. No clear correlation between microplastics and the finer sediment fraction was found. Rayon, polyester, and acrylic were the most abundant types of microplastics identified, indicating that the main source of microplastics in the Changjiang Estuary was from washing clothes (the primary source). It is possible to compare microplastic abundance in this study with the results of other related studies using the same quantification method. The identification of microplastics raises the awareness of microplastic pollution from drainage systems. The prevalence of microplastic pollution calls for monitoring microplastics at a national scale on a regular basis.

Peng G ，Zhu B ，Yang D ，Su L ，Shi H ，Li D ... -  《-》

Research and management of plastic pollution in coastal environments of China.

Marine plastic waste has become an ever-increasing environmental threat in the world's ocean largely due to their unique properties and ubiquitous occurrence. They include diverse forms of land- and ocean-based sources of plastics and are estimated to account for up to 85% of marine debris worldwide. As secondary pollutants, marine microplastic particles (<5 mm) are derived from pellet loss and degradation of macroplastics. Up to now, several reports have proposed negative impacts of both macro-sized and micro-sized plastics on marine biota. As one of the rapidly growing economies, China is the topmost contributor of plastic waste in the world. China's massive impact on the plastic levels of the ocean are a definite cause of concern and is developing multiple economic, environmental and biological complications. The research of plastics impact on coastal environments in China is only incipient. Here we review the available information on plastic waste, their impacts on marine biota and human health, and Chinese government policies and management initiatives. Although Chinese coastal environments (surface water, coastal sediments, water column) are affected by microplastics pollution, both from land-based and sea-based activities, their impacts on marine biota remain to be elucidated. Though national-level policies are modern and well suited for minimizing the impacts of plastic pollution, there is hardly any legislation for containment of microplastic pollution. Our objective is to review and summarize the information about the occurrence, impacts, and management of plastic pollution in the Chinese coastal environments in order to comprehend their widespread repercussions. MAIN FINDING: Microplastics are increasingly being detected and quantified in Chinese coastal environments and legislation for containment of such pollution is highly recommended.

Wang MH ，He Y ，Sen B 《-》