Morphological and Biomechanical Features in Abdominal Aortic Aneurysm with Long and Short Neck-Case-Control Study in 64 Abdominal Aortic Aneurysms.

Both, open and endovascular, procedures are related to higher complication rate in abdominal aortic aneurysm (AAA) with shorter neck. Previous study showed that long-neck AAA might have lower risk of rupture. Estimation of biomechanical forces in AAA improves rupture risk assessment. The aim of this study was to compare morphological features and biomechanical forces in the short- and long-neck AAA with threshold of 15 mm. Digital Imaging and Communication in Medicine images of 64 aneurysms were prospectively collected and analyzed in a case-control study. Using commercially available software, Peak wall Stress (PWS) and Rupture Risk Equivalent Diameter (RRED) were determined. Difference between the maximal aneurysm diameter (MAD) and RRED was calculated and expressed as an absolute and relative (percentage of the MAD) value. In addition, volume of intraluminal thrombus (ILT) was calculated and expressed relative to AAA volume. Study included 64 AAA divided in group with long (36, 56.25%), and short (28, 43.75%) neck. There was no correlation between neck length and MAD, PWS, and RRED (P = 0.646, P = 0.421, and P = 0.405, respectively). Relative ILT volume was greater in the short-neck aneurysms (P = 0.033). Relative difference between RRED and MAD was -4% and -14.8% in short- and long-neck aneurysms, respectively (P = 0.029). The difference between RRED and MAD was positive in 14/28 patients (50%) with short neck and in 6/35 patients (17.14%) with long neck (P = 0.011). Based on our biomechanical analysis, in AAA with neck longer than 15 mm rupture risk might be lower than the risk estimated by its diameter. It might be explained with lower relative volume of ILT.

Koncar IB ，Nikolic D ，Milosevic Z ，Ilic N ，Dragas M ，Sladojevic M ，Markovic M ，Filipovic N ，Davidovic L ... -  《-》

Estimation of Abdominal Aortic Aneurysm Rupture Risk with Biomechanical Imaging Markers.

To evaluate whether the biomechanical marker known as rupture risk equivalent diameter (RRED) was superior to the actual abdominal aortic aneurysm (AAA) diameter in estimating future rupture risk in patients who had undergone pre-rupture computed tomography (CT) angiography. A retrospective study was conducted in 13 patients with ruptured AAAs who had undergone CT angiography before and after rupture between 2001 and 2015. The median time between the 2 scans was 731 days. Biomechanical and geometrical markers such as maximal AAA diameter, peak wall stress (PWS), and RRED were calculated with AAA-dedicated software. The main analyses determined whether RRED was higher than the actual diameter and the threshold diameter for elective surgery (55 mm for men, 50 mm for women) in AAAs before and after rupture. Differences between diameter and biomechanical markers before and after rupture were tested with appropriate statistical tests. RRED before and after rupture was smaller than the actual diameter in 7 of 13 cases. Post-rupture RRED was estimated to be smaller than the threshold diameter for elective repair in 4 cases, again suggesting a low rupture risk. The median PWS before and after rupture was 181.7 kPa (interquartile range [IQR], 152.1-244.2 kPa) and 274.1 kPa (IQR, 172.2-377.2 kPa), respectively. RRED was smaller than the actual diameter in more than half of pre-rupture AAAs, suggesting a lower rupture risk than estimated with the actual diameter. The results suggest that the currently available biomechanical imaging markers might not be ready for use in clinical practice.

Jalalzadeh H ，Leemans EL ，Indrakusuma R ，Planken RN ，Koelemay MJW ，Zeebregts CJ ，Marquering HA ，van der Laan MJ ，Balm R ... -  《-》

Intraluminal thrombus is associated with early rupture of abdominal aortic aneurysm.

The implications of intraluminal thrombus (ILT) in abdominal aortic aneurysm (AAA) are currently unclear. Previous studies have demonstrated that ILT provides a biomechanical advantage by decreasing wall stress, whereas other studies have associated ILT with aortic wall weakening. It is further unclear why some aneurysms rupture at much smaller diameters than others. In this study, we sought to explore the association between ILT and risk of AAA rupture, particularly in small aneurysms. Patients were retrospectively identified and categorized by maximum aneurysm diameter and rupture status: small (<60 mm) or large (≥60 mm) and ruptured (rAAA) or nonruptured (non-rAAA). Three-dimensional AAA anatomy was digitally reconstructed from computed tomography angiograms for each patient. Finite element analysis was then performed to calculate peak wall stress (PWS) and mean wall stress (MWS) using the patient's systolic blood pressure. AAA geometric properties, including normalized ILT thickness (mean ILT thickness/maximum diameter) and % volume (100 × ILT volume/total AAA volume), were also quantified. Patients with small rAAAs had PWS of 123 ± 51 kPa, which was significantly lower than that of patients with large rAAAs (242 ± 130 kPa; P = .04), small non-rAAAs (204 ± 60 kPa; P < .01), and large non-rAAAs (270 ± 106 kPa; P < .01). Patients with small rAAAs also had lower MWS (44 ± 14 kPa vs 82 ± 20 kPa; P < .02) compared with patients with large non-rAAAs. ILT % volume and normalized ILT thickness were greater in small rAAAs (68% ± 11%; 0.16 ± 0.04 mm) compared with small non-rAAAs (53% ± 16% [P = .02]; 0.11 ± 0.04 mm [P < .01]) and large non-rAAAs (57% ± 12% [P = .02]; 0.12 ± 0.03 mm [P < .01]). Increased ILT % volume was associated with both decreased MWS and decreased PWS. This study found that although increased ILT is associated with lower MWS and PWS, it is also associated with aneurysm rupture at smaller diameters and lower stress. Therefore, the protective biomechanical advantage that ILT provides by lowering wall stress seems to be outweighed by weakening of the AAA wall, particularly in patients with small rAAAs. This study suggests that high ILT burden may be a surrogate marker of decreased aortic wall strength and a characteristic of high-risk small aneurysms.

Haller SJ ，Crawford JD ，Courchaine KM ，Bohannan CJ ，Landry GJ ，Moneta GL ，Azarbal AF ，Rugonyi S ... -  《-》

On the influence of wall calcification and intraluminal thrombus on prediction of abdominal aortic aneurysm rupture.

Parameters other than maximum diameter that predict rupture of abdominal aortic aneurysms (AAAs) may be helpful for risk-benefit analysis in individual patients. The aim of this study was to characterize the biomechanical-structural characteristics associated with AAA walls to better identify the related mechanistic variables required for an accurate prediction of rupture risk. Anterior AAA wall (n = 40) and intraluminal thrombus (ILT; n = 114) samples were acquired from 18 patients undergoing open surgical repair. Biomechanical characterization was performed using controlled circumferential stretching tests combined with a speckle-strain tracking technique to quantify the spatial heterogeneity in deformation and localized strains in the AAA walls containing calcification. After mechanical testing, the accompanying microstructural characteristics of the AAA wall and ILT types were examined using electron microscopy. No significant correlation was found between the AAA diameter and the wall mechanical properties in terms of Cauchy stress (rs = -0.139; P = .596) or stiffness (rs = -0.451; P = .069). Quantification of significant localized peak strains, which were concentrated in the tissue regions surrounding calcification, reveals that peak strains increased by a mean of 174% as a result of calcification and corresponding peak stresses by 18.2%. Four ILT types characteristic of diverse stages in the evolving tissue microstructure were directly associated with distinct mechanical stiffness properties of the ILT and underlying AAA wall. ILT types were independent of geometric factors, including ILT volume and AAA diameter measures (ILT stiffness and AAA diameter [rs = -0.511; P = .074]; ILT stiffness and ILT volume [rs = -0.245; P = .467]). AAA wall stiffness properties are controlled by the load-bearing capacity of the noncalcified tissue portion, and low stiffness properties represent a highly degraded vulnerable wall. The presence of calcification that is contiguous with the inner wall causes severe tissue overstretching in surrounding tissue areas. The results highlight the use of additional biomechanical measures, detailing the biomechanical-structural characteristics of AAA tissue, that may be a helpful adjunct to improve the accuracy of rupture prediction.

Barrett HE ，Cunnane EM ，Hidayat H ，O'Brien JM ，Moloney MA ，Kavanagh EG ，Walsh MT ... -  《-》

Prediction of Rupture Sites in Abdominal Aortic Aneurysms After Finite Element Analysis.

To associate regions of highest local rupture risk from finite element analysis (FEA) to subsequent rupture sites in abdominal aortic aneurysms (AAA). This retrospective multicenter study analyzed computed tomography angiography (CTA) data from 13 asymptomatic AAA patients (mean age 76 years; 8 men) experiencing rupture at a later point in time between 2005 and 2011. All patients had CTA scans before and during the rupture event. FEA was performed to calculate peak wall stress (PWS), peak wall rupture risk (PWRR), rupture risk equivalent diameters (RRED), and the intraluminal thrombus volume (ILTV). PWS and PWRR locations in the prerupture state were compared with subsequent CTA rupture findings. Visible contrast extravasation was considered a definite (n=5) rupture sign, while a periaortic hematoma was an indefinite (n=8) sign. A statistical comparison was performed between the 13-patient asymptomatic AAA group before and during rupture and a 23-patient diameter-matched asymptomatic AAA control group that underwent elective surgery. The asymptomatic AAAs before rupture showed significantly higher PWRR and RRED values compared to the matched asymptomatic AAA control group (median values 0.74 vs 0.52 and 77 vs 59 mm, respectively; p<0.0001 for both). No statistical differences could be found for PWS and ILTV. Ruptured AAAs showed the highest maximum diameters, PWRR, and RRED values. In 7 of the ruptured AAAs (2 definite and 5 indefinite rupture signs), CTA rupture sites correlated with prerupture PWRR locations. The location of the PWRR in unruptured AAAs predicted future rupture sites in several cases. Asymptomatic AAA patients with high PWRR and RRED values have an increased rupture risk.

Erhart P ，Roy J ，de Vries JP ，Liljeqvist ML ，Grond-Ginsbach C ，Hyhlik-Dürr A ，Böckler D ... -  《-》