Surviving High-Temperature Calcination: ZrO(2) -Induced Hematite Nanotubes for Photoelectrochemical Water Oxidation.

Nanotubular Fe2 O3 is a promising photoanode material, and producing morphologies that withstand high-temperature calcination (HTC) is urgently needed to enhance the photoelectrochemical (PEC) performance. This work describes the design and fabrication of Fe2 O3 nanotube arrays that survive HTC for the first time. By introducing a ZrO2 shell on hydrothermal FeOOH nanorods by atomic layer deposition, subsequent high-temperature solid-state reaction converts FeOOH-ZrO2 nanorods to ZrO2 -induced Fe2 O3 nanotubes (Zr-Fe2 O3 NTs). The structural evolution of the hematite nanotubes is systematically explored. As a result of the nanostructuring and shortened charge collection distance, the nanotube photoanode shows a greatly improved PEC water oxidation activity, exhibiting a photocurrent density of 1.5 mA cm-2 at 1.23 V (vs. reversible hydrogen electrode, RHE), which is the highest among hematite nanotube photoanodes without co-catalysts. Furthermore, a Co-Pi decorated Zr-Fe2 O3 NT photoanode reveals an enhanced onset potential of 0.65 V (vs. RHE) and a photocurrent of 1.87 mA cm-2 (at 1.23 V vs. RHE).

Li C ，Li A ，Luo Z ，Zhang J ，Chang X ，Huang Z ，Wang T ，Gong J ... -  《-》

Enhanced Charge Separation through ALD-Modified Fe2 O3 /Fe2 TiO5 Nanorod Heterojunction for Photoelectrochemical Water Oxidation.

Hematite suffers from poor charge transport and separation properties for solar water splitting. This paper describes the design and fabrication of a 3D Fe2 O3 /Fe2 TiO5 heterojunction photoanode with improved charge separation, via a facile hydrothermal method followed by atomic layer deposition and air annealing. A highly crystallized Fe2 TiO5 phase forms with a distinct interface with the underlying Fe2 O3 core, where a 4 nm Fe2 TiO5 overlayer leads to the best photoelectrochemical performance. The favorable band offset between Fe2 O3 and Fe2 TiO5 establishes a type-II heterojunction at the Fe2 O3 /Fe2 TiO5 interface, which drives electron-hole separation effectively. The Fe2 O3 /Fe2 TiO5 composite electrode exhibits a dramatically improved photocurrent of 1.63 mA cm(-2) at 1.23 V versus reversible hydrogen electrode (RHE) under simulated 1 sun illumination (100 mW cm(-2) ), which is 3.5 times that of the bare Fe2 O3 electrode. Decorating the Fe2 O3 /Fe2 TiO5 heterojunction photoanode with earth-abundant FeNiOx cocatalyst further expedites surface reaction kinetics, leading to an onset potential of 0.8 V versus RHE with a photocurrent of 2.7 mA cm(-2) at 1.23 V and 4.6 mA cm(-2) at 1.6 V versus RHE. This sandwich photoanode shows an excellent stability for 5 h and achieves an overall Faradaic efficiency of 95% for O2 generation. This is the best performance ever reported for Fe2 O3 /Fe2 TiO5 photoanodes.

Li C ，Wang T ，Luo Z ，Liu S ，Gong J ... -  《-》

Dual-Axial Gradient Doping (Zr and Sn) on Hematite for Promoting Charge Separation in Photoelectrochemical Water Splitting.

One of the crucial challenges to enhance the photoelectrochemical water-splitting performance of hematite (α-Fe2 O3 ) is to resolve its very fast charge recombination in bulk. Herein, we describe the design and fabrication of dual-axial gradient-doping on 1D Fe2 O3 nanorod arrays with Zr doping for x-axial and Sn doping for y-axial directions to promote the charge separation. This dual-axial gradient-doping structure fulfills the requirements of a greater electron-carrier concentration for increasing conductivity as well as a higher charge-separation efficiency across the dual-axial direction of Fe2 O3 nanorods, ultimately showing an excellent photocurrent density of 1.64 mA cm-2 at 1.23 V vs. RHE, which is 26.3 times more than that of the bare Fe2 O3 . Furthermore, the remarkably improved photocurrent density, when comparing the uniform Zr-doped Fe2 O3 nanorod arrays (1.0 mA cm-2 at 1.23 V vs. RHE) with dual-axial gradient-doped (Zr and Sn) Fe2 O3 nanorod arrays, highlights the additional charge-separation effect resulting from gradient codoping of Zr and Sn. Hence, this promising design may provide guidelines for dual-axial gradient doping into photoelectrodes to realize efficient PEC water splitting.

Chen D ，Liu Z 《-》

Efficient Photoelectrochemical Water Oxidation on Hematite with Fluorine-Doped FeOOH and FeNiOOH as Dual Cocatalysts.

An effective cocatalyst is usually required to improve the performance of photoelectrochemical (PEC) water splitting catalysts. A fluorine-doped FeOOH (F:FeOOH) cocatalyst on a hematite photoanode was used to lower the onset potential by 140 mV and significantly improve the PEC performance. Moreover, a more effective dual cocatalytic system was prepared by subsequent loading of a FeNiOOH cocatalyst, which resulted in a further decrease of the onset potential by 270 mV. The final onset potential of the Fe2 O3 /F:FeOOH/FeNiOOH photoanode was lowered to 0.45 V versus the reversible hydrogen electrode (RHE), which is one of the lowest onset potential values ever reported for hematite photoanodes. The photocurrent also dramatically increased by a factor of approximately 3 to 0.9 mA cm-2 at 1.0 V versus RHE. Based on the structural, chemical, and electrochemical impedance spectroscopy characterization, the enhanced performance was attributed to the F:FeOOH overlayer, which reduced the surface recombination and accelerated the oxygen evolution reaction activity, and the FeNiOOH cocatalyst, which further enhanced the reaction kinetics. The facile preparation of the F:FeOOH cocatalyst and the design of the dual cocatalytic system will allow the development of high-performance hematite photoanodes.

Deng J ，Zhang Q ，Feng K ，Lan H ，Zhong J ，Chaker M ，Ma D ... -  《-》

Enhanced Photoelectrochemical Water Oxidation Performance in Bilayer TiO(2) /α-Fe(2) O(3) Nanorod Arrays Photoanode with Cu : NiO(x) as Hole Transport Layer and Co-Pi as Cocatalyst.

Efficient charge transfer and excellent surface water oxidation kinetics are key factors in determining the photoelectrochemical (PEC) water splitting performance in photoelectrodes. Herein, a bilayer TiO2 /α-Fe2 O3 nanorod (NR) arrays photoanode was prepared with deposited Cu-doped NiOx (Cu : NiOx ) hole transport layer (HTL) and Co-Pi oxygen evolution reaction (OER) cocatalyst for PEC water oxidation. The hierarchical TiO2 /α-Fe2 O3 composite obtained by a secondary hydrothermal process exhibited an inapparent bilayer structure by embedding the underlayer TiO2 NR arrays at the bottom part of the post-grown α-Fe2 O3 NR arrays. The underlayer TiO2 NRs acted as an effective shuttling pathway for transferring photoelectrons generated in the upper hematite light absorber layer. A p-type inter-Cu : NiOx HTL was introduced to form a build-in p-n electric field between Cu : NiOx and α-Fe2 O3 NRs, which improved the hole extraction from α-Fe2 O3 to Co-Pi OER catalyst. As expected, the as-engineered TiO2 /α-Fe2 O3 /Cu : NiOx /Co-Pi photoanode displayed an excellent photocurrent density of 2.43 mA cm-2 at 1.23 V versus the reversible hydrogen electrode (VRHE ), up to 4.05 and 2.23 times greater than those of the bare α-Fe2 O3 (0.60 mA cm-2 ) and TiO2 /α-Fe2 O3 , respectively. The results demonstrate that the bottom-up engineering of electron-hole transport channels and cocatalyst modification is an attractive maneuver to enhance the PEC water oxidation activity in hematite and other photoanodes.

Li H ，Yin M ，Li X ，Mo R ... -  《-》