Microplastics in Singapore's coastal mangrove ecosystems.

The prevalence of microplastics was studied in seven intertidal mangroves habitats of Singapore. Microplastics were extracted from mangrove sediments via a floatation method, and then counted and categorized according to particle shape and size. Representative microplastics from Berlayar Creek, Sungei Buloh, Pasir Ris and Lim Chu Kang were isolated for polymer identification using Attenuated Total Reflectance-Fourier Transform Infrared (ATR-FTIR) spectroscopy. Microplastics were identified in all seven habitats, with the highest concentration found in sediments at Lim Chu Kang in the northwest of Singapore. The majority of microplastics were fibrous and smaller than 20 μm. A total of four polymer types were identified, including polyethylene, polypropylene, nylon and polyvinyl chloride. The relationship between abundance of microplastics and sediment grain size was also investigated, but no relationship was apparent. The presence of microplastics is likely due to the degradation of marine plastic debris accumulating in the mangroves.

Nor NH ，Obbard JP 《-》

Prevalence of microplastics in Singapore's coastal marine environment.

Ng KL ，Obbard JP 《MARINE POLLUTION BULLETIN》

Characterization, source, and retention of microplastic in sandy beaches and mangrove wetlands of the Qinzhou Bay, China.

Severe microplastic pollution from anthropogenic activities in coastal zones presents an imminent risk to marine ecosystems. In this study, abundant microplastics (15-12,852 items kg-1) with sizes ranging between 0.16 and 5.0 mm were extracted from 17 sediment samples collected in sandy beaches and mangrove wetlands of the Qinzhou Bay, Guangxi Province, Southwest China. Three types of microplastics (i.e. polystyrene, polypropylene, and polyethylene) were identified with Fourier transform infrared (FTIR) spectroscopy analysis. These detected microplastics were characterized by different colors (white, transparent, yellow, green, red, and blue) and shapes (fragment, fiber, and sphere). Microplastics were concentrated on supratidal beaches and wetlands outside of mangrove, and less abundant on intertidal beaches and inside of mangrove wetlands. Meanwhile, high microplastic concentrations were observed near mollusk farms. The spatial distribution and chemical speciation indicated that microplastics were derived from disintegration of large plastic debris (e.g., Styrofoam buoys used to support mollusk rafts) abandoned by aquaculture industry. Further, coastal vegetation (e.g. mangrove) could trap microplastic particles.

Li J ，Zhang H ，Zhang K ，Yang R ，Li R ，Li Y ... -  《-》

The applicability of reflectance micro-Fourier-transform infrared spectroscopy for the detection of synthetic microplastics in marine sediments.

Synthetic microplastics (≤5-mm fragments) are globally distributed contaminants within coastal sediments that may transport organic pollutants and additives into food webs. Although micro-Fourier-transform infrared (micro-FT-IR) spectroscopy represents an ideal method for detecting microplastics in sediments, this technique lacks a standardized operating protocol. Herein, an optimized method for the micro-FT-IR analysis of microplastics in vacuum-filtered sediment retentates was developed. Reflectance micro-FT-IR analyses of polyethylene (PE) were compared with attenuated total reflectance FT-IR (ATR-FT-IR) measurements. Molecular mapping as a precursor to the imaging of microplastics was explored in the presence and absence of 150-μm PE fragments, added to sediment at concentrations of 10, 100, 500 and 1000ppm. Subsequently, polymer spectra were assessed across plastic-spiked sediments from fifteen offshore sites. While all spectra obtained of evenly shaped plastics were typical to PE, reflectance micro-FT-IR measurements of irregularly shaped materials must account for refractive error. Additionally, we provide the first evidence that mapping successfully detects microplastics without their visual selection for characterization, despite this technique relying on spectra from small and spatially separated locations. Flotation of microplastics from sediments only enabled a fragment recovery rate of 61 (±31 S.D.) %. However, mapping 3-mm(2) areas (within 47-mm filters) detected PE at spiking concentrations of 100ppm and above, displaying 69 (±12 S.D.) % of the fragments in these locations. Additionally, mapping detected a potential PE fragment in a non-spiked retentate. These data have important implications for research into the imaging of microplastics. Specifically, the sensitivity and spatial resolution of the present protocol may be improved by visualizing the entire filter with high-throughput detection techniques (e.g., focal plane array-based imaging). Additionally, since micro-FT-IR analyses depend on methods of sample collection, our results emphasize the urgency of developing efficient and reproducible techniques to separate microplastics from sediments.

Harrison JP ，Ojeda JJ ，Romero-González ME 《-》

Microplastics in coastal sediments from Southern Portuguese shelf waters.

Microplastics are well-documented pollutants in the marine environment that result from fragmentation of larger plastic items. Due to their long chemical chains, they can remain in the environment for long periods of time. It is estimated that the vast majority (80%) of marine litter derives from land sources and that 70% will sink and remain at the bottom of the ocean. Microplastics that result from fragmentation of larger pieces of plastic are common to be found in beaches and in the water surface. The most common microplastics are pellets, fragments and fibres. This work provides original data of the presence of microplastics in coastal sediments from Southern Portuguese shelf waters, reporting on microplastic concentration and polymer types. Microplastic particles were found in nearly 56% of sediment samples, accounting a total of 31 particles in 27 samples. The vast majority were microfibers (25), identified as rayon fibres, and fragments (6) identified as polypropylene, through infrared spectroscopy (μ-FTIR). The concentration and polymer type data is consistent with other relevant studies and reports worldwide.

Frias JP ，Gago J ，Otero V ，Sobral P ... -  《-》