Sulfite (SPORL) pretreatment of switchgrass for enzymatic saccharification.

SPORL (Sulfite Pretreatment to Overcome Recalcitrance of Lignocellulose) pretreatment was applied to switchgrass and optimized through an experimental design using Response Surface Methodology within the range of temperature (163-197 °C), time (3-37 min), sulfuric acid dosage (0.8-4.2% on switchgrass), and sodium sulfite dosage (0.6-7.4% on switchgrass). Performance of SPORL was compared with that of dilute acid (DA) and alkali (AL) in switchgrass pretreatment. Results indicated that SPORL pretreatment improved the digestibility of switchgrass through sufficiently removing hemicellulose, partially dissolving lignin, and reducing hydrophobicity of lignin by sulfonation. The removal of hemicellulose was more critical to substrate digestibility than the removal of lignin during SPORL pretreatment. SPORL pretreated switchgrass had better enzymatic digestibility than DA and AL pretreated ones. The SPORL pretreated switchgrass could be hydrolyzed by 83% within 48 h with 15 FPU (filter paper unit) cellulase and 30 CBU (cellobiose unit) β-glucosidase/g cellulose.

Zhang DS ，Yang Q ，Zhu JY ，Pan XJ ... -  《-》

Sulfite pretreatment to overcome recalcitrance of lignocellulose (SPORL) for robust enzymatic saccharification of hardwoods.

This study demonstrates sulfite pretreatment to overcome recalcitrance of lignocellulose (SPORL) for robust bioconversion of hardwoods. With only about 4% sodium bisulfite charge on aspen and 30-min pretreatment at temperature 180 degrees C, SPORL can achieve near-complete cellulose conversion to glucose in a wide range of pretreatment liquor of pH 2.0-4.5 in only about 10 h enzymatic hydrolysis. The enzyme loading was about 20 FPU cellulase plus 30 CBU beta-glucosidase per gram of cellulose. The production of fermentation inhibitor furfural was less than 20 mg/g of aspen wood at pH 4.5. With pH 4.5, SPORL avoided reactor corrosion problem and eliminated the need for substrate neutralization prior to enzymatic hydrolysis. Similar results were obtained from maple and eucalyptus.

Wang GS ，Pan XJ ，Zhu JY ，Gleisner R ，Rockwood D ... -  《-》

Sulfite pretreatment (SPORL) for robust enzymatic saccharification of spruce and red pine.

Zhu JY ，Pan XJ ，Wang GS ，Gleisner R ... -  《-》

Effects of SPORL and dilute acid pretreatment on substrate morphology, cell physical and chemical wall structures, and subsequent enzymatic hydrolysis of lodgepole pine.

Li X ，Luo X ，Li K ，Zhu JY ，Fougere JD ，Clarke K ... -  《-》

Comparative study of SPORL and dilute-acid pretreatments of spruce for cellulosic ethanol production.

The performance of two pretreatment methods, sulfite pretreatment to overcome recalcitrance of lignocellulose (SPORL) and dilute acid (DA), was compared in pretreating softwood (spruce) for fuel ethanol production at 180 degrees Celsius for 30 min with a sulfuric acid loading of 5% on oven-dry wood and a 5:1 liquor-to-wood ratio. SPORL was supplemented with 9% sodium sulfite (w/w of wood). The recoveries of total saccharides (hexoses and pentoses) were 87.9% (SPORL) and 56.7% (DA), while those of cellulose were 92.5% (SPORL) and 77.7% (DA). The total of known inhibitors (furfural, 5-hydroxymethylfurfural, and formic, acetic and levulinic acids) formed in SPORL were only 35% of those formed in DA pretreatment. SPORL pretreatment dissolved approximately 32% of the lignin as lignosulfonate, which is a potential high-value co-product. With an enzyme loading of 15 FPU (filter paper units) per gram of cellulose, the cellulose-to-glucose conversion yields were 91% at 24h for the SPORL substrate and 55% at 48 h for the DA substrate, respectively.

Shuai L ，Yang Q ，Zhu JY ，Lu FC ，Weimer PJ ，Ralph J ，Pan XJ ... -  《-》