An automated SPE-based high-yield synthesis of [11C]acetate and [11C]palmitate: no liquid-liquid extraction, solvent evaporation or distillation required.

An automated method is described for the rapid and high-yield synthesis of two of the most commonly used radioactive fatty acids: [(11)C]acetate and [(11)C]palmitate. Reaction of [(11)C]CO(2) with the respective Grignard reagents in diethyl ether solution proceeded for 2 min at 40°C. Quenching of the reaction and liberation of nonreacted [(11)C]CO(2) occurred upon addition of a fourfold molar excess of aqueous 0.1 M HCl (acetate) or nonaqueous HCl/Et(2)O (palmitate). Labeled products were then purified by adsorption to an Alumina-N Sep-Pak Plus cartridge and eluted with either aqueous NaH(2)PO(4) solution (acetate) or 100% ethanol (palmitate). High-performance liquid chromatography analysis confirmed that the radiochemical purity of each product was >98%, and decay-corrected radiochemical yields averaged 33% for [(11)C]palmitate and 40% for [(11)C]acetate. The method requires no liquid-liquid extraction, solvent evaporation or distillation capabilities and can be readily adapted to existing radiosynthesis modules.

Mock BH ，Brown-Proctor C ，Green MA ，Steele B ，Glick-Wilson BE ，Zheng QH ... -  《-》

Fully automated synthesis of ¹¹C-acetate as tumor PET tracer by simple modified solid-phase extraction purification.

Automated synthesis of (11)C-acetate ((11)C-AC) as the most commonly used radioactive fatty acid tracer is performed by a simple, rapid, and modified solid-phase extraction (SPE) purification. Automated synthesis of (11)C-AC was implemented by carboxylation reaction of MeMgBr on a polyethylene Teflon loop ring with (11)C-CO2, followed by acidic hydrolysis with acid and SCX cartridge, and purification on SCX, AG11A8 and C18 SPE cartridges using a commercially available (11)C-tracer synthesizer. Quality control test and animals positron emission tomography (PET) imaging were also carried out. A high and reproducible decay-uncorrected radiochemical yield of (41.0 ± 4.6)% (n=10) was obtained from (11)C-CO2 within the whole synthesis time about 8 min. The radiochemical purity of (11)C-AC was over 95% by high-performance liquid chromatography (HPLC) analysis. Quality control test and PET imaging showed that (11)C-AC injection produced by the simple SPE procedure was safe and efficient, and was in agreement with the current Chinese radiopharmaceutical quality control guidelines. The novel, simple, and rapid method is readily adapted to the fully automated synthesis of (11)C-AC on several existing commercial synthesis module. The method can be used routinely to produce (11)C-AC for preclinical and clinical studies with PET imaging.

Tang X ，Tang G ，Nie D 《-》

Captive solvent [11C]acetate synthesis in GMP conditions.

Soloviev D ，Tamburella C 《APPLIED RADIATION AND ISOTOPES》

Fully automated preparation of [11C]choline and [18F]fluoromethylcholine using TracerLab synthesis modules and facilitated quality control using analytical HPLC.

Modifications of a GE TracerLab FX(C-Pro), which can be implemented for solid-phase [(11)C]methylation are described. The simplified procedure for synthesis of [(11)C]choline uses a single Sep-Pak CM-Light cation-exchange cartridge for both solid-supported reaction and purification. Compared with the commonly used two Sep-Pak method, the low back-pressure of this Sep-Pak enables efficient and reliable production of [(11)C]choline using a TracerLab FX(C-Pro) without requirement for any gas pressure adjustment. Typical radiochemical yields (RCY) are >60%, radiochemical purity (RCP) is 99.9% and levels of residual precursor in the final product, which may inhibit the uptake of [(11)C]choline, are reduced to 1 μg/mL. Similarly, modification of a GE TracerLab FX(FN) is reported which enables gas-phase production of [(18)F]fluoromethylcholine, suitable for pre-clinical use, (in 4-6% RCY and >99.7% RCP) using a related Sep-Pak method. These modifications can be utilized for solid-phase [(11)C]methylation and [(18)F]fluoromethylation of other radiotracers, and allow straightforward switching to other module configurations for solution-phase radiochemistry or loop chemistry. In addition, we report a convenient HPLC ion chromatography method, which can monitor residual precursor and the radiochemical purity of product at the same time, providing highly efficient quality control for routine clinical application. The reported HPLC method is appropriate for analysis of doses of both [(11)C]choline and [(18)F]fluoromethylcholine, and eliminates the need for a GC method to determine residual precursor levels.

Shao X ，Hockley BG ，Hoareau R ，Schnau PL ，Scott PJ ... -  《-》

Radiosynthesis of the D2/3 agonist [3-11C]-(+)-PHNO using [11C]iodomethane.

We report here a radiosynthesis for the D(2/3) agonist (+)-4-([3-(11)C]propyl)-3,4,4a,5,6,10b-hexahydro-2H-naphtho[1,2-b][1,4]oxazin-9-ol (3-[(11)C]-(+)-PHNO) labelled at the terminal carbon of the N-propyl chain. The protocol is based on (11)C-methylation of an N-acetyl precursor. This initial step is followed by a reduction with LiAlH(4) to give ([3-(11)C]-(+)-PHNO). We first applied the method for the synthesis of a model compound, N-3-([(11)C]propyl)-1,2,3,4-tetrahydroisoquinoline, which we obtained in 77-97% analytical radiochemical yield (n=6) in 20 min. Similarly, we prepared ([3-(11)C]-(+)-PHNO) in 55-60% analytical radiochemical yield (n=5) using a one-pot procedure. We have also been able to implement the complete process on a semi-automated module. This platform delivered purified and formulated [3-(11)C]PHNO with an average radiochemical yield of 9% (n=13, range 2-30%, non-decay corrected), a radiochemical purity >95%, and a specific radioactivity of 26.8-81.1 GBq/μmol in a total time of 63-65 min.

Francisco Garcia-Arguello S ，Fortt R ，Steel CJ ，Brickute D ，Glaser M ，Turton DR ，Robins EG ，Arstad E ，Luthra SK ... -  《-》