Surface-enhanced Raman scattering of 4-aminobenzenethiol in Ag sol: relative intensity of a1- and b2-type bands invariant against aggregation of Ag nanoparticles.

4-Aminobenzenthiol (4-ABT) is an unusual molecule, showing variable surface-enhanced Raman scattering (SERS) spectra depending upon measurement conditions. In an effort to reduce ambiguity and add clarity, we have thus conducted an ultraviolet-visible (UV-vis) extinction measurement, along with Raman scattering measurement, after adding 4-ABT into aqueous Ag sol. Upon the addition of 4-ABT, the surface plasmon absorption band of Ag at 410 nm gradually diminished and, concomitantly, a weak and broad band developed at longer wavelengths, obviously because of the aggregation of Ag nanoparticles. At the same time, the Raman scattering peaks of 4-ABT varied in intensity as the Ag particles proceeded to form aggregates. A close examination revealed that the peak intensity of the ring 7a band of 4-ABT, a typical a(1) vibrational mode, could be correlated with the UV-vis extinction of the Ag sol measured at the excitation laser wavelength. In a separate Raman measurement conducted using sedimented Ag colloidal particles, 4-ABT was found not to be subjected to any surface-induced photoreaction, implying that all of the observable Raman peaks were, in fact, solely due to 4-ABT on Ag. The intensities of the b(2)-type bands, such as the ring 3, 9b, and 19b modes of 4-ABT, were then analyzed and found to be invariant with respect to the 7a band, irrespective of the extent of Ag aggregation as far as at a fixed excitation wavelength. The intensity ratio of the b(2)-type/7a bands would then reflect the extent of the chemical enhancement that was involved in the SERS of 4-ABT in aggregated Ag sol.

Kim K ，Yoon JK ，Lee HB ，Shin D ，Shin KS ... -  《-》

Raman scattering of 4-aminobenzenethiol sandwiched between Ag nanoparticle and macroscopically smooth Au substrate: effects of size of Ag nanoparticles and the excitation wavelength.

A nanogap formed by a metal nanoparticle and a flat metal substrate is one kind of "hot site" for surface-enhanced Raman scattering (SERS). Accordingly, although no Raman signal is observable when 4-aminobenzenethiol (4-ABT), for instance, is self-assembled on a flat Au substrate, a distinct spectrum is obtained when Ag or Au nanoparticles are adsorbed on the pendent amine groups of 4-ABT. This is definitely due to the electromagnetic coupling between the localized surface plasmon of Ag or Au nanoparticle with the surface plasmon polariton of the planar Au substrate, allowing an intense electric field to be induced in the gap even by visible light. To appreciate the Raman scattering enhancement and also to seek the optimal condition for SERS at the nanogap, we have thoroughly examined the size effect of Ag nanoparticles, along with the excitation wavelength dependence, by assembling 4-ABT between planar Au and a variable-size Ag nanoparticle (from 20- to 80-nm in diameter). Regarding the size dependence, a higher Raman signal was observed when larger Ag nanoparticles were attached onto 4-ABT, irrespective of the excitation wavelength. Regarding the excitation wavelength, the highest Raman signal was measured at 568 nm excitation, slightly larger than that at 632.8 nm excitation. The Raman signal measured at 514.5 and 488 nm excitation was an order of magnitude weaker than that at 568 nm excitation, in agreement with the finite-difference time domain simulation. It is noteworthy that placing an Au nanoparticle on 4-ABT, instead of an Ag nanoparticle, the enhancement at the 568 nm excitation was several tens of times weaker than that at the 632.8 nm excitation, suggesting the importance of the localized surface plasmon resonance of the Ag nanoparticles for an effective coupling with the surface plasmon polariton of the planar Au substrate to induce a very intense electric field at the nanogap.

Kim K ，Choi JY ，Lee HB ，Shin KS ... -  《-》

Effect of Ag and Au nanoparticles on the SERS of 4-aminobenzenethiol assembled on powdered copper.

Kim K ，Lee HS 《-》

Surface-enhanced Raman scattering characteristics of nanogaps formed by a flat Ag substrate and spherical Pt nanoparticles.

We estimated the apparent size of the 'hot site' for surface-enhanced Raman scattering (SERS) located within the gaps between Pt nanoparticles and a flat Ag substrate. Initially, no Raman peaks were detected for 4-aminobenzenethiol (4-ABT) on a flat Ag substrate. Upon attaching 68 nm-sized Pt nanoparticles onto the amine group of 4-ABT (thus denoted as Pt-4-ABT/Ag(flat)), Raman peaks were distinctly observed, not only with the excitation at 488 nm but also with the excitation at 632.8 nm. This means that electromagnetic 'hot site' had formed at the gaps between Pt nanoparticles and a flat Ag substrate. When 4-ABT molecules were adsorbed additionally onto the vacant sites of Pt nanoparticles in Pt-4-ABT/Ag(flat), the Raman signal did not increase further, suggesting that the SERS 'hot site' was very limited and located mostly at the gaps between Pt nanoparticles and a flat Ag substrate, in agreement with the finite-difference time-domain (FDTD) calculation. To a rough estimate, about 1000 molecules residing only within a ~15 nm diameter area of the center of the gap must have contributed most of the measured Raman signal of 4-ABT.

Kim K ，Lee HB ，Shin KS 《-》

Effect of volatile organic chemicals on surface-enhanced Raman scattering of 4-aminobenzenethiol on Ag: comparison with the potential dependence.

4-Aminobenzenethiol (4-ABT) is an unusual molecule in the sense that several distinct peaks whose counterparts are rarely found in the normal Raman spectrum are observed in its surface-enhanced Raman scattering (SERS) spectra. Their origin has been argued over recently as due to either a metal-to-adsorbate charge transfer or the formation of a photoreaction product such as dimercaptoazobenzene (DMAB). In an electrochemical SERS measurement, the intensities of the new peaks depended strongly not only on the excitation wavelength but also on the electrode potential. Interestingly, we observed a similar spectral variation even under ambient conditions by exposure of 4-ABT on Ag to volatile organic chemicals (VOCs) such as acetone and ammonia. Since acetone and ammonia barely react directly with 4-ABT, the effect of VOCs must be indirect, presumably associated with the movement of electrons between VOCs and the Ag substrate causing either an increase or a decrease in the surface potential of Ag. Based on the potential-dependent SERS data, the effect of acetone therefore appeared to correspond to an application of +0.15 V to the Ag substrate vs. a saturated Ag/AgCl electrode, while the effect of ammonia corresponded to the application of -0.45 V to Ag. We admit that much the same VOC effect could be observable if a photoproduct was formed immediately upon irradiation and the product was also subjected to a chemical enhancement mechanism. The Gaussian response of the peak intensities of the b(2)-type bands to applied potential, as well as to VOCs, dictated that the new peaks appearing in the SERS of 4-ABT have nothing to do with any electrochemical reaction. In addition, a separate preliminary work suggested that the b(2)-type bands are not at least due to a photoreaction product such as DMAB.

Kim K ，Kim KL ，Choi JY ，Shin D ，Shin KS ... -  《-》